Updated November 2026
The salomon adv skin 5 set hydration pack is a small running vest built around a soft-flask and bladder system, sized for short trail runs and fast-paced hikes. To get the most from it, set the fit first, then fill and seat the water carriers, and finally distribute gear so the load stays close to your torso. Most fit and comfort problems come from skipping one of those steps.
Why the Fit Decides How the Pack Feels
Vest-style hydration packs live or die by fit. A vest that sits too low or too loose will bounce, rub under the arms and pull at the shoulders once the flasks are full. Salomon’s adv skin line is designed to cinch snugly against the torso, so the first job is to tighten the sternum strap and the side compression straps until the pack stops moving when you lift your arms overhead.
Shopping for one? See our guide: 3 Best Salomon Advanced Skin 12 Hydration Packs (2026): Our Picks.
Manufacturers generally specify that the pack should ride high on the back, with the bottom sitting just above the waist. If the bottom edge drops below the hip line, the weight pulls backward and you will feel it in your lower back on climbs.
Filling, Seating and Balancing the Water
Water weighs about 8.3 pounds per gallon, so a full set of carriers adds real weight. Keep that weight centered. Fill the soft flasks partway, screw the caps down, and seat them in the front pockets with the bite valves on the shoulder straps. Avoid stuffing a single flask full and leaving the other empty, because the uneven load will shift on every stride.
Gear goes in the rear and side pockets. Put heavier items, such as a phone or a layer, close to your back and as high as possible. Lighter items like gels and wrappers belong in the outer pockets where they will not affect balance.
Practical Steps for Your First Few Runs
- Tighten the sternum strap to a comfortable level, then adjust the side straps until the vest hugs your ribs.
- Fill each soft flask with the same amount of water and seat them evenly in the front pockets.
- Run a short loop with the empty pack first to check for rubbing, then repeat with water.
- Route the drink tubes so they do not catch on your chest or pull the valve when you turn your head.
- Rinse the flasks and tubes after each use and let them air dry with the caps off to prevent odor.
- Check the seams and bite valve monthly for cracks or mold, and replace worn parts before a long outing.
What we’d use
A spare soft flask with a wide opening makes refilling at streams and taps far easier, and it fits the same front pockets. View on Amazon
For cleaning the tubes between runs, a bottle brush and drying kit keeps the inside of the bladder free of residue. View on Amazon
FAQ
Can I use a bladder instead of soft flasks?
Many vest packs accept a hydration bladder in the back compartment, but the adv skin pack is built around its front-pocket flasks. Check the manufacturer’s compatibility notes before buying a bladder.
How much water should I carry?
Plan roughly half a liter per hour in warm conditions as a starting point, then adjust for your own sweat rate. Consult a medical professional if you have a condition that affects fluid intake.
How often should I clean the system?
Rinse after every outing and do a full cleaning with a mild soap and a tube brush at least once a week if you use it often.

